Main linac lattice design and optimization for <I>E</I><SUB>cm</SUB>=1 TeV CLIC

WANG Yi-Wei; SCHULTE Daniel; GAO Jie

doi:10.1088/1674-1137/38/6/067009

Chinese Physics C> 2014, Vol. 38> Issue(6) : 067009 DOI: 10.1088/1674-1137/38/6/067009

Main linac lattice design and optimization for E_cm=1 TeV CLIC

Abstract
HTML
Reference
Related

PDF

Abstract：
The Compact Linear Collider (CLIC) is a future e⁺e^- linear collider. The CLIC study concentrated on a design of center-of-mass energy of 3 TeV and demonstrated the feasibility of the technology. However, the physics also demands lower energy collision. To satisfy this, CLIC can be built in stages. The actual stages will depend on LHC results. Some specific scenarios of staged constructions have been shown in CLIC Concept Design Report (CDR). In this paper, we concentrate on the main linac lattice design for E_cm=1 TeV CLIC aiming to upgrade from E_cm=500 GeV CLIC and then to E_cm=3 TeV one. This main linac accelerates the electron or positron beam from 9 GeV to 500 GeV. A primary lattice design based on the 3 TeV CLIC main linac design and its optimization based on the beam dynamics study will be presented. As we use the same design principles as 3TeV CLIC main linac, this optimization is basically identical to the 3 TeV one. All the simulations results are obtained using the tracking code PLACET.

References

[1]

Aicheler M, Burrows P, Draper M et al. CLIC Conceptual Design Report, CERN-2012-007[2] Balakin V, Novakhatsky A, Smirnow V. Proc. of 12th Int. Conf. on High Energy Accelerators, Fermilab, 1983[3] Schulte D. Beam-Based Alignment in the New CILC Main Linac, CLIC-Note-804[4] Latina A et al. Recent Improvements in the Tracking Code PLACET. Proc. of 11th biennial European Particle Accelerator Conference, Genoa, Italy, 2008[5] Baklakov B A et al. Proc. of IEEE Particle Accelerator Conf., San Francisco, USA, 1991. 3273-3275[6] Schulte D. The Lectures on Main Linac. 5th Linear Collider School. 2010[7] Schulte D. Multi-Bunch Calculations in the CLIC Main Linac, CLIC-Note-805[8] Schulte D. Emittance Preservation in the Main Linac of CLIC. Proc. 23rd IEEE Particle Accelerator Conf., Vancouver, Canada. 2009. 3808-3810[9] Raubenheimer Tor O. The Generation and Acceleration of Low-Emittance Flat Beams for Future Linear Collider (Ph.D. thesis). Stanford University, 1992, Chapter 3.4.1.1

[1]	Constanza Callender , Alfonso R. Zerwekh . A dark vector resonance at CLIC. Chinese Physics C, 2019, 43(6): 063102. doi: 10.1088/1674-1137/43/6/063102
[2]	Gang Xu , Yi Jiao , Yue-Mei Peng . ESRF-type lattice design and optimization for the High Energy Photon Source. Chinese Physics C, 2016, 40(2): 027001. doi: 10.1088/1674-1137/40/2/027001
[3]	FU Zi-Wen . I=1/2 low-lying mesons in lattice QCD. Chinese Physics C, 2015, 39(8): 083101. doi: 10.1088/1674-1137/39/8/083101
[4]	ZHANG Xiao-Hu , YUAN You-Jin , XIA Jia-Wen , YIN Xue-Jun , DU Heng , LI Zhong-Shan . Conceptional design of a heavy ion linac injector for HIRFL-CSRm. Chinese Physics C, 2014, 38(10): 107002. doi: 10.1088/1674-1137/38/10/107002
[5]	ZHU Hong-Yan , DONG Lan , LI Bo . Design and simulation of a wire position monitor for cryogenicsystems in an ADS linac. Chinese Physics C, 2014, 38(8): 087001. doi: 10.1088/1674-1137/38/8/087001
[6]	XU Gang , JIAO Yi . Towards the ultimate storage ring: The lattice design forBeijing Advanced Photon Source. Chinese Physics C, 2013, 37(5): 057003. doi: 10.1088/1674-1137/37/5/057003
[7]	WANG Dou , GAO Jie , XIAO Ming , GENG Hui-Ping , GUO Yuan-Yuan , XU Shou-Yan , WANG Na , AN Yu-Wen , QIN Qing , XU Gang , WANG Sheng . Optimization parameter design of a circular e⁺e^- Higgs factory. Chinese Physics C, 2013, 37(9): 097003. doi: 10.1088/1674-1137/37/9/097003
[8]	SUN Lie-Peng , ZHAO Hong-Wei , SUN Zhou-Ping , HE Yuan , SHI Ai-Min , XIAO Chen , DU Xiao-Nan , ZHANG Cong , ZHANG Zhou-Li . Design study of the SSC-LINAC re-buncher. Chinese Physics C, 2013, 37(2): 027002. doi: 10.1088/1674-1137/37/2/027002
[9]	YANG Liu , LU Xiang-Yang , QUAN Sheng-Wen , YAO Zhong-Yuan , LUO Xing , ZHOU Kui . Electromagnetic design and optimization of a superconducting quarter wave resonator. Chinese Physics C, 2013, 37(2): 027001. doi: 10.1088/1674-1137/37/2/027001
[10]	BAI Zheng-He , WANG Lin , JIA Qi-Ka , LI Wei-Min . Lattice optimization for the HLS-Ⅱ storage ring. Chinese Physics C, 2013, 37(1): 017001. doi: 10.1088/1674-1137/37/1/017001
[11]	LU Bo , CUI Wei-Wei , WANG Yu-Sa , ZHU Yue , ZHANG Yi , XU Yu-Peng , CHEN Yong , HUO Jia , LI Wei , HAN Da-Wei , LI Mao-Shun , YANG Yan-Ji , WANG Juan , CHEN Tian-Xiang , HU Wei , LI Cheng-Kui , LIU Xiao-Yan . Design and optimization of the readout system for X-ray CCDs. Chinese Physics C, 2012, 36(9): 846-850. doi: 10.1088/1674-1137/36/9/009
[12]	GAO Wei-Wei , WANG Lin , LI Wei-Min , HE Duo-Hui . Low emittance lattice optimization using a multi-objective evolutionary algorithm. Chinese Physics C, 2011, 35(9): 859-864. doi: 10.1088/1674-1137/35/9/014
[13]	WANG Dou , GAO Jie . Single-bunch emittance dilution in the perfect ILC main linac. Chinese Physics C, 2011, 35(3): 296-300. doi: 10.1088/1674-1137/35/3/016
[14]	TIAN Shun-Qiang . A design strategy of achievable linear optics for a complex storage ring lattice. Chinese Physics C, 2010, 34(7): 1009-1015. doi: 10.1088/1674-1137/34/7/015
[15]	FENG Guang-Yao , PEI Yuan-Ji , WANG Lin , ZHANG Shan-Cai , WU Cong-Feng , JIN Kai , LI Wei-Min . Physical design of a 10 MeV LINAC for polymer radiation processing. Chinese Physics C, 2009, 33(S2): 135-138. doi: 10.1088/1674-1137/33/S2/035
[16]	SUI Yan-Feng , MA Hui-Zhou , CAO Jian-She , MA Li . Design and simulation of the wire scanner for the injector linac of BEPCⅡ. Chinese Physics C, 2008, 32(5): 397-399. doi: 10.1088/1674-1137/32/5/015
[17]	Chen Qizhou , Fang Xiyan , Guo Shouhong . Calculation of Vacuum State for 2+1-Dimensional SU(3) Lattice Gauge Theory. Chinese Physics C, 1995, 19(S3): 265-272.
[18]	Zheng Bo , Guo Shuohong . Exact Solution for a 1 + 1 Dimensional Lattice U (1) Gauge Model. Chinese Physics C, 1990, 14(S2): 163-167.
[19]	Liu Jinming , Zheng Weihong , Guo Shuohong . The Mass Gap in 2 + 1 Dimensional SU(3) Lattice Gauge Theory. Chinese Physics C, 1988, 12(S2): 137-142.
[20]	Zheng Weihong , Liu Jinming , Guo Shuohong . The Mass Gap in 2 + 1 Dimensional SU(2) Lattice Gauge Theory. Chinese Physics C, 1988, 12(S1): 51-54.

Access

Get Citation

WANG Yi-Wei, SCHULTE Daniel and GAO Jie. Main linac lattice design and optimization for E_cm=1 TeV CLIC[J]. Chinese Physics C, 2014, 38(6): 067009. doi: 10.1088/1674-1137/38/6/067009

WANG Yi-Wei, SCHULTE Daniel and GAO Jie. Main linac lattice design and optimization for E_cm=1 TeV CLIC[J]. Chinese Physics C, 2014, 38(6): 067009. doi: 10.1088/1674-1137/38/6/067009 shu

RIS(for EndNote,Reference Manager,ProCite)

BibTex

Txt

Milestone

Received: 2013-08-07
Revised: 1900-01-01

Article Metric

Article Views(1617)
PDF Downloads(241)
Cited by(0)

Policy on re-use

To reuse of subscription content published by CPC, the users need to request permission from CPC, unless the content was published under an Open Access license which automatically permits that type of reuse.

通讯作者: 陈斌, bchen63@163.com

1.
沈阳化工大学材料科学与工程学院沈阳 110142

Main linac lattice design and optimization for E_cm=1 TeV CLIC

Corresponding author: SCHULTE Daniel,

Received Date: 2013-08-07

Accepted Date: 1900-01-01

Available Online: 2014-06-05

Abstract: The Compact Linear Collider (CLIC) is a future e⁺e^- linear collider. The CLIC study concentrated on a design of center-of-mass energy of 3 TeV and demonstrated the feasibility of the technology. However, the physics also demands lower energy collision. To satisfy this, CLIC can be built in stages. The actual stages will depend on LHC results. Some specific scenarios of staged constructions have been shown in CLIC Concept Design Report (CDR). In this paper, we concentrate on the main linac lattice design for E_cm=1 TeV CLIC aiming to upgrade from E_cm=500 GeV CLIC and then to E_cm=3 TeV one. This main linac accelerates the electron or positron beam from 9 GeV to 500 GeV. A primary lattice design based on the 3 TeV CLIC main linac design and its optimization based on the beam dynamics study will be presented. As we use the same design principles as 3TeV CLIC main linac, this optimization is basically identical to the 3 TeV one. All the simulations results are obtained using the tracking code PLACET.

HTML

Reference (1)

Main linac lattice design and optimization for E_cm=1 TeV CLIC

Abstract：

References

Access

Article Metrics

Metrics

通讯作者: 陈斌, bchen63@163.com

Email This Article

Main linac lattice design and optimization for E_cm=1 TeV CLIC

Corresponding author: SCHULTE Daniel,

HTML

目录

Main linac lattice design and optimization for Ecm=1 TeV CLIC

Abstract：

References

Access

Article Metrics

Metrics

通讯作者: 陈斌, bchen63@163.com

Email This Article

Main linac lattice design and optimization for Ecm=1 TeV CLIC

Corresponding author: SCHULTE Daniel,

HTML

目录

Main linac lattice design and optimization for E_cm=1 TeV CLIC

Main linac lattice design and optimization for E_cm=1 TeV CLIC